Bosch Washer dr:15 Gives an Early Warning From the Power Limiter

What dr:15 means

Consider dr:15 a yellow light. The inverter in a Vision washer logs it when the motor is working near its power limit but hasn't passed it. Bosch gives it the same causes and fixes as the shutdown code, an overloaded drum or friction, and tells technicians to look at the suspension and the door gasket.

Common causes of dr:15

Loads that are regularly full to the top
Bearings or suspension starting to wear
Gasket beginning to scrape the drum

✓ One safe check you can try

1. Cut the size of your loads for the next few washes. 2. Start by turning off the breaker that feeds the washer. 3. Spin the empty drum by hand, listening for scraping or a heavy spot. 4. Run your hand around the door gasket and check whether it touches the drum. Finding drag at the warning stage costs less than after the drive trips.

! Why to stop there

Treating the warning as a one-off lets friction wear bearings further.
A rubbing gasket can tear and leak if ignored.
Forcing the drum while power is on is unsafe.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

dr:22Bosch Washer dr:22 Reports Failure of the Inverter's Own Temperature Sensor dr:19Bosch Washer dr:19 Shows That the Motor Phases Don't Match dr:20Bosch Washer dr:20 Signals a Shorted Inverter Output Stage dr:21Sustained High Voltage and Bosch Washer dr:21 Er:21Bosch Washer Er:21 Reports Too Much Foam Er:22Er:22 on a Bosch Washer That Can't Lock On to the Power Supply Er:24Bosch Washer Er:24 Names the Relay That Feeds the Motor Drive Er:25Bosch Washer Er:25 When the Door Lock Coil Overheats

dr:15dr:15 questions

Do I have to stop washing now?

Not necessarily. Smaller loads often make the warning disappear. If it continues on light loads, schedule a check before the drive shuts off completely. Lighter loads also help the bearings.

How do I know if the gasket is the cause?

Look for rubbing marks or a pinched edge where the gasket meets the drum. A gasket that has shifted or stretched can drag and add friction.

Will dr:15 turn into dr:10?

If the cause isn't addressed, it can. The limiter logs the warning first and trips the drive if the draw keeps climbing. Acting early keeps it from happening.