Bosch Washer E:17: No Water Arriving at the Inlet
On 300 Series front-load washers such as the WAP24200UC, WAP24201UC, and WAP24202UC, E:17 is a water inlet code, not a drain code. Bosch's table lists the water tap not turned on, the supply hose kinked or…
- Code
- E17
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What E17 means
On 300 Series front-load washers such as the WAP24200UC, WAP24201UC, and WAP24202UC, E:17 is a water inlet code, not a drain code. Bosch's table lists the water tap not turned on, the supply hose kinked or pinched, the inlet strainer clogged, or water pressure too low. You will see an empty or partly filled drum, a washer that waits, and the code on the display.
Common causes of E17
- Water tap closed or partly closed
- Supply hose kinked or pinched
- Inlet strainer clogged
- Water pressure too low
1. Open both taps behind the washer fully. 2. Check the hoses for kinks and pull the washer forward gently if needed. 3. Check pressure at a nearby faucet. 4. If you know how, close the taps and clean the hose-end strainers over a towel. Restart. If E:17 stays, call us.
- Clogged strainers can reduce flow without being obvious.
- A failing inlet valve behaves the same, so a pressure check separates it from a supply issue.
- Written price first, then work.
Technical reference
- Code
- E17
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
Is E:17 the same as Er:17?
No. On the Vision 16, Er:17 is an Aquastop error. On the 300 Series, E:17 is a no-water code. Check the prefix and your model.
What are E:16 and E:18 on this washer?
On the same table, E:16 is a door that is not closed properly and E:18 is too much or non-HE detergent, or a blocked pump.
How clean should the strainers be?
Free of sediment, and the washers seated in the hose ends. We can clean and test them during a visit. Sediment can build up in the filter screens, so they should be clean and free of grit. The rubber washers must sit flat in the hose ends.
Still seeing E17?
A technician diagnoses it on site and gives you the price in writing before any work starts.