Bosch Washer Er:06: Temperature Sensor Reads as Shorted
Er:06 is the opposite reading of Er:05 on Nexxt front-load washers like the WFMC6400UC and on Vision 16 WFVC models. The control sees the water temperature sensor (NTC) as shorted, which Bosch ties to a damaged…
- Code
- Er:06
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What Er:06 means
Er:06 is the opposite reading of Er:05 on Nexxt front-load washers like the WFMC6400UC and on Vision 16 WFVC models. The control sees the water temperature sensor (NTC) as shorted, which Bosch ties to a damaged sensor or a short in its wire harness. The washer cannot judge water heat, so it halts the cycle and shows the code. The display shows the code as soon as the control reads the circuit.
Common causes of Er:06
- NTC temperature sensor shorted
- Short in the sensor wire harness
1. Press Off and unplug the washer for about five minutes. 2. Reconnect power and start a cold rinse. 3. If Er:06 comes back, stop and do not run warm or hot programs. 4. Keep the front and rear panels closed. A shorted wire may be rubbing on metal, and it should be examined by a technician.
- A short can come from the sensor itself or from a chafed wire, and those are two different repairs.
- Wiring near the drum and heater moves with every spin, so a repair that ignores the route may fail again.
- You get a written quote before we replace the sensor or any wiring.
Technical reference
- Code
- Er:06
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
How is Er:06 different from Er:05?
Er:05 reads the sensor circuit as broken, like an unplugged wire. Er:06 reads it as shorted, like two wires touching. Both stop the wash for the same reason: no usable temperature.
Could a short like this overheat my water?
The control uses the sensor to shut the heater off, so we take it seriously. Do not run heated cycles until the washer is checked.
Does the WFMC3200UC use the same code?
It prints the same list with E:06 in place of Er:06, and our approach to the repair is the same on both. Either way, the sensor circuit is what we test first.
Still seeing Er:06?
A technician diagnoses it on site and gives you the price in writing before any work starts.