Bosch Washer Er:16: Pressure Sensor Cannot Set Its Zero
Er:16 appears on the WFMC6400UC, a Nexxt front-load washer, and not on the Vision 16 table. The documented meaning is that the pressure sensor cannot be calibrated, due to a bad sensor or a bad wire…
- Code
- Er:16
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What Er:16 means
Er:16 appears on the WFMC6400UC, a Nexxt front-load washer, and not on the Vision 16 table. The documented meaning is that the pressure sensor cannot be calibrated, due to a bad sensor or a bad wire harness. At the start of a cycle the control checks the empty-tub reading; if it cannot set that baseline, it stops and shows the code.
Common causes of Er:16
- Pressure sensor not reading a stable zero level
- Wire harness to the sensor damaged
1. Turn the dial to Off and unplug the washer for five minutes. 2. Make sure the drum is empty and the door is closed. 3. Plug it in and select a short rinse. 4. If Er:16 returns, stop. Do not tilt the washer or open the cabinet. Tell us the model number when you call.
- The reading is taken before the water enters, so a bad sensor and a bad harness give the same stop.
- Opening the cabinet to look at the sensor exposes line voltage, which is why we keep it a technician task.
- Price in writing before we order a sensor.
Technical reference
- Code
- Er:16
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
What is calibration here?
It is the control's check of what 'empty' looks like before filling. Bosch treats a failure at that step as a sensor or wiring problem.
Is it the same as Er:15?
They are close. Er:15 is a voltage outside the expected range; Er:16 is a failure to set the baseline. Both lead to the same sensor circuit.
Is it an issue with leftover water?
The official table does not say so. We start with the sensor and harness, but a quick look at the drum is part of the visit.
Still seeing Er:16?
A technician diagnoses it on site and gives you the price in writing before any work starts.