Booking today · Houston · three-hour arrival windows Independent Bosch specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 568-9298 Schedule a Visit
Error code · Washer

Bosch Washer Er:20: Spin Stopped by an Unbalanced Load

Er:20 shows on Nexxt front-load washers such as the WFMC6400UC and on Vision 16 WFVC models; the WFMC3200UC prints E:20. The documented meaning is that spinning was aborted because the load is unbalanced; on the Vision,…

Low risk · DIY check OK
Code
Er:20
Appliance
Washer
Brand
Bosch
Warranty
30-day workmanship

What Er:20 means

Er:20 shows on Nexxt front-load washers such as the WFMC6400UC and on Vision 16 WFVC models; the WFMC3200UC prints E:20. The documented meaning is that spinning was aborted because the load is unbalanced; on the Vision, the spin ended for unbalance or lost communication with the inverter. Wet clothes sit in the drum at the end of the cycle. The load may still be soaked when you open the door.

Common causes of Er:20

  • Unbalanced or tangled load
  • Wire harness to the motor drive damaged
✓ One safe check you can try

1. Turn the washer off and open the door. 2. Pull the clothes apart and spread them out evenly. 3. Add or remove items so the drum has a mix of small and large pieces. 4. Run Spin only. If Er:20 repeats with a balanced load, stop and call us; do not push the washer.

! Why to stop there
  • If the load is balanced and the code keeps coming back, the cause may be the motor communication path.
  • Repeated spin attempts with a bad harness can stress the drive.
  • We tell you what we find before any price is quoted.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

Technical reference

Code
Er:20
Appliance
Bosch washer
Checked
October 2026

We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.

Er:20Er:20 questions
Is a single bath mat a problem?

Yes, one heavy item can unbalance a spin. Wash it with a few towels so the weight spreads around the drum. Using a few towels as ballast often fixes the repeat.

Why did the washer stop instead of just spinning slower?

The control aborts the spin when the drum sways too much, to protect the bearings and the cabinet. A wet, lopsided drum can hit the cabinet at high speed, and the control prevents that on purpose.

What if it happens with small loads too?

Then the load may not be the cause. A wiring or drive problem can end the spin early, and we would check that. We would also look at the shock absorbers and wiring.

Book a visit

Still unsure about Er:20?

A technician diagnoses it on site and gives you the price in writing before any work starts.

☎ Call our office ▤ Schedule a Visit