Bosch Washer dr:22: Inverter Temperature Sensor Has Failed
On Vision 16 WFVC front-load washers, dr:22 reports an IGBT temperature sensor error; the manual names no US E-Nr, and the code is absent from Nexxt and current WAT, WAW, and WAP models. Bosch says the…
- Code
- dr:22
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What dr:22 means
On Vision 16 WFVC front-load washers, dr:22 reports an IGBT temperature sensor error; the manual names no US E-Nr, and the code is absent from Nexxt and current WAT, WAW, and WAP models. Bosch says the sensor is damaged and the inverter should be changed. The inverter cannot watch its own heat, so it stops the drive and displays the code.
Common causes of dr:22
- Temperature sensor inside the inverter damaged
- Wire harness to the inverter sensor damaged
1. Turn the washer off and unplug it for a few minutes. 2. Plug back in and try a short rinse. 3. If dr:22 returns, stop. 4. Do not open the cabinet or touch the drive. Give us the model number from the door frame when you call.
- The sensor is part of the inverter, so the repair is replacing the unit, not adjusting something.
- Operating without temperature protection is not safe for the drive.
- The price is quoted in writing before we order.
Technical reference
- Code
- dr:22
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
Is dr:22 related to dr:06?
They are neighbors. dr:06 is a hot inverter or stuck relay; dr:22 is the inverter's own sensor failing. One tells you the electronics are hot. The other tells you the sensor that watches them is gone.
Can the sensor be replaced alone?
Bosch's remedy is to change the inverter, since the sensor is built into it. We confirm the diagnosis and give you the replacement price in writing, so there are no surprises.
Will resetting hide the code?
A reset may clear the display, but without the sensor the drive will stop again. Please do not rely on a reset. Running without temperature protection is a risk to the drive.
Still seeing dr:22?
A technician diagnoses it on site and gives you the price in writing before any work starts.