Bosch Range E010 (Panel Could Not Save Its Settings)

What E010 means

E010 appears when the range's user interface fails to read or write its stored data. This is the memory that keeps settings and calibration, which is separate from the memory that holds the operating program. While the error is active, Bosch disables all heating elements, so the range will not cook. The manual notes it is canceled at start-up when the memory checks out again.

Common causes of E010

Settings memory in the interface that has become corrupted
A write to memory that was cut off by a power interruption
Memory chip on the interface board that is failing

✓ One safe check you can try

1. Switch the range off at the breaker for two minutes, then turn it back on. 2. Look at the clock and any oven temperature adjustment you had set. 3. If they went back to factory values, the memory did lose its contents, which is useful news for us. 4. If E010 stays, do not keep cycling power; call us.

! Why to stop there

Cycling power again and again on a failing memory risks losing the remaining stored data.
The memory chip sits on the interface board, so a wrong guess means replacing the wrong board.
Calibration lost along the way shows up later as food that bakes unevenly.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

F91Bosch Range F91 Means the Unlock Attempts Ran Out F92Bosch Range F92: Oven Believes the Door Is Open F93Bosch Range F93 Is the Lock-Side Twin of F90 F94Bosch Range F94: Door Lock Attempts Exhausted E122Bosch Range E122? Check the Meat Probe First E126Bosch Range E126 and the Latch Switch That Went Silent E201Bosch Range E201 Is About the Warming Drawer E302Bosch Range E302 Warns That the Control Board Is Too Hot

E010E010 questions

Will my oven calibration survive?

Probably not, since that value lives in the memory this code concerns. Expect to set the clock and any temperature offset again afterward. It is a nuisance but not a danger, and we can re-enter them for you after the repair.

Is this the same problem as the program memory error?

No. That one is about the operating program, while this one is about stored data. Bosch gives them separate numbers for that reason. Both are real memory checks, but they point to different parts of the board and different repairs.

Does the warranty cover this?

It depends on your purchase date and terms, so check those first. Any repair we do has a 30-day workmanship warranty and a written price in advance.