Bosch Range E106 and the Door Latch That Would Not Lock

What E106 means

Start a self-clean, watch it quit, and see E106. The control asked the oven door latch to lock and never got confirmation. Bosch spells out the limit: if no lock is confirmed inside a minute, the attempts end. The error then lapses once a locked door is not needed, so everyday baking keeps working and the problem appears only when a clean is requested.

Common causes of E106

Spill residue that keeps the door from closing true
Latch motor or its switch that has died
Broken wiring between the control module and the latch

✓ One safe check you can try

1. Make sure the oven is off and cold. 2. Inspect the door gasket and the recess where the latch hook lands for baked-on spills; on a range the door hangs low and gets splashed. 3. Confirm no pan or rack is nudging the door ajar. 4. If everything is clean and E106 returns, book a visit.

! Why to stop there

Chipping at the latch area with a blade can bend the hook.
A latch that fails only during cleaning is easy to blame on the control and replace at the wrong end.
Repeating clean cycles to test it pours heat into a cavity whose lock is unconfirmed.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

F91Bosch Range F91 Means the Unlock Attempts Ran Out F92Bosch Range F92: Oven Believes the Door Is Open F93Bosch Range F93 Is the Lock-Side Twin of F90 F94Bosch Range F94: Door Lock Attempts Exhausted F13Bosch Range F13 Signals Corrupted Stored Settings F30Bosch Range F30: Reading 1080 to 1110 Ohms on the Oven Sensor F31Bosch Range F31, the Shorted Twin of F30 F90Bosch Range F90 After Self-Clean: The Door Would Not Unlock

E106E106 questions

Is baking still possible with E106 around?

Typically yes. Regular baking never locks the door, and Bosch drops the error once no lock is demanded, so the oven keeps cooking normally. Only the cleaning feature is affected.

Why does it show only on clean days?

Self-clean is the one job that asks the latch to work. A tired latch hides through months of ordinary cooking until that cycle gets selected. Normal use never exercises the lock mechanism.

Does a dirty gasket really matter?

It can. If spills keep the door from seating squarely, the latch has nothing to grab. A cleanup sometimes solves it; if not, we measure the motor and switch and quote in writing.