Bosch Range F13: Control Memory Checksum Mismatch
F13 on Bosch Evolution 300 and 500 Series freestanding ranges with the ES337 control, such as the HGS3023UC, HGS3063UC and HGS5053UC, is the Bad EEPROM Identification or checksum error. The control found its stored settings did…
- Code
- F13
- Appliance
- Range
- Brand
- Bosch
- Warranty
- 30-day workmanship
What F13 means
F13 on Bosch Evolution 300 and 500 Series freestanding ranges with the ES337 control, such as the HGS3023UC, HGS3063UC and HGS5053UC, is the Bad EEPROM Identification or checksum error. The control found its stored settings did not add up, which Bosch treats as an internal error. The recommended first step is a 30-second power cycle, then control module replacement if it persists.
Common causes of F13
- Stored settings in the control failing their checksum
- Control module internal error
- Power surge that damaged the stored data
1. Turn the range's breaker off and leave it for at least 30 seconds. 2. Restore power and check the display. 3. If F13 shows up again, leave the range off. 4. Call us with your model and serial numbers; the control module is the likely repair.
- Memory trouble cannot be corrected from the keypad.
- Repeated resets will not rewrite damaged data.
- Panels near the control carry mains voltage.
Technical reference
- Code
- F13
- Appliance
- Bosch range
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Range codes
What is a checksum?
It is a number the control calculates from its saved settings. If the stored number and the new one disagree, the data is treated as unreliable.
Does F13 mean the same as F12?
They are both internal control module errors. F12 is about identification of the processor, while F13 concerns the stored memory. Neither one is cleared from the keypad.
Could a power surge have done it?
It can. We would check the supply and the board. We quote in writing before work and back the repair with a 30-day warranty. Do not keep power cycling it.
Still seeing F13?
A technician diagnoses it on site and gives you the price in writing before any work starts.