Bosch Dishwasher E:01: Cycle Ended Early, Heater Relay or Pump Circuit
On Bosch 800 Series dishwashers such as the SHEM63W55N and SHEM63W52N, and on the SHEM78W55N and SHP65TL5UC, E:01 means the wash cycle finished prematurely. The control could not confirm the heat pump heater relay, the heat…
- Code
- E:01
- Appliance
- Dishwasher
- Brand
- Bosch
- Warranty
- 30-day workmanship
What E:01 means
On Bosch 800 Series dishwashers such as the SHEM63W55N and SHEM63W52N, and on the SHEM78W55N and SHP65TL5UC, E:01 means the wash cycle finished prematurely. The control could not confirm the heat pump heater relay, the heat or drain pump connection, or enough supply voltage. You will see the far right LED flashing and dishes that are only partly washed. Bosch also publishes the same list for its older heat pump designs.
Common causes of E:01
- Low supply voltage or a large voltage drop on the kitchen circuit
- Heat pump or drain pump disconnected at the power module harness
- Heat pump heater relay on the power module has failed
- Heat pump or drain pump itself is defective
1. Turn the dishwasher off at the breaker for one minute, then restore power. 2. Check that nothing heavy, such as a disposer, shares its circuit while it runs. 3. Start a short cycle and watch whether E:01 returns. 4. If it does, stop and leave the lower panel closed. Pump and relay checks need meter readings from a technician.
- Pump and relay checks require measurements at the power module that are unsafe for a homeowner.
- A low-voltage cause can look identical to a failed relay, so guessing leads to the wrong part.
- The power module is only replaced after the pumps and wiring are proven good.
Technical reference
- Code
- E:01
- Appliance
- Bosch dishwasher
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Dishwasher codes
Why did the dishwasher stop partway through?
The control ended the cycle early because it could not confirm the heater relay, the pumps, or the incoming voltage. The far right LED flashes to tell you.
Can a power dip cause E:01?
Yes. Low supply voltage is one of the listed causes. If the code appears only now and then, a weak circuit is worth checking before any part is changed.
Do you quote before working?
Yes. We give a written price before any work starts, and our repairs carry a 30-day workmanship warranty. That includes checking the pump harness and, if needed, a test program run, so the fix is matched to the real cause.
Still seeing E:01?
A technician diagnoses it on site and gives you the price in writing before any work starts.