Bosch Washer E:93: Hot Water Did Not Arrive
On 300 Series front-load washers such as the WAT28400UC, WAT28401UC, and WAT28402UC, E:93 means the hot water supply was missing. Bosch lists the hot tap not turned on, a kinked hot hose, low hot-water pressure, or…
- Code
- E:93
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What E:93 means
On 300 Series front-load washers such as the WAT28400UC, WAT28401UC, and WAT28402UC, E:93 means the hot water supply was missing. Bosch lists the hot tap not turned on, a kinked hot hose, low hot-water pressure, or a clogged strainer. It shows at the end of the first cycle that ran without hot water, not in later cycles, and resets after a second cycle that does get hot water.
Common causes of E:93
- Hot water tap closed or partly closed
- Hot supply hose kinked
- Hot-water pressure too low
- Hot inlet strainer clogged
1. Open the hot tap behind the washer fully. 2. Check the hot hose, usually marked red or H, for kinks. 3. Run a nearby hot faucet to confirm hot water reaches the house line. 4. Close the taps, clean the hot hose-end strainer over a towel if you are comfortable, and run a hot cycle. If E:93 returns, call us.
- The strainer or valve may need cleaning or replacing, and we check pressure before replacing anything.
- If the hose connections are swapped, hot cycles will not heat as expected.
- You see the price in writing before any work starts.
Technical reference
- Code
- E:93
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
Is E:93 an error I need to fix right away?
Not urgent. Bosch says it clears after a second cycle that receives hot water. Fix the supply so it does not repeat, and the display will stay clear.
Why did it only show once?
It appears at the end of the first cycle without hot water, not in later ones, so you may see it just once. Later cycles will not repeat it.
Could the hoses be swapped?
Yes, that is worth checking. The hot hose should go to the hot tap. Swapped hoses mean cold water on hot cycles and this code.
Still unsure about E:93?
A technician diagnoses it on site and gives you the price in writing before any work starts.