Booking today · Houston · three-hour arrival windows Independent Bosch specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 568-9298 Schedule a Visit
Error code · Washer

Bosch Washer E:16: Door Is Not Closed Properly

E:16 appears on 300 Series front-load washers such as the WAP24200UC, WAP24201UC, and WAP24202UC. Bosch's table says the door was not closed properly and tells you to check that no laundry is caught in the door…

Low risk · DIY check OK
Code
E:16
Appliance
Washer
Brand
Bosch
Warranty
30-day workmanship

What E:16 means

E:16 appears on 300 Series front-load washers such as the WAP24200UC, WAP24201UC, and WAP24202UC. Bosch's table says the door was not closed properly and tells you to check that no laundry is caught in the door and to close it securely. The washer will not begin or continue the cycle, and the display shows the code. You may also hear the washer hold off filling.

Common causes of E:16

  • Laundry caught in the door opening
  • Door not latched securely
  • Door latch or switch not registering
✓ One safe check you can try

1. Open the door and remove any sock, strap, or garment caught in the opening. 2. Wipe the seal and the latch area. 3. Close the door firmly until it clicks. 4. Press Start. If E:16 returns with the door fully closed, stop and call us.

! Why to stop there
  • A latch that does not register may need replacing.
  • Forcing the door can damage it.
  • We quote in writing before any part.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

Technical reference

Code
E:16
Appliance
Bosch washer
Checked
October 2026

We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.

E:16E:16 questions
Is E:16 on newer models too?

This table covers the 300 Series WAP24200 family. Other models may show similar codes, so we match your model number to the right list. Bring the model number.

The door clicks shut. Why the code?

The latch or door switch may not signal back to the control. We test the latch and its wiring, then quote in writing before replacing any part.

How does E:17 differ?

On the same table E:17 is a water inlet problem and E:16 is the door. The two are easy to tell apart by whether the drum fills.

Book a visit

Still unsure about E:16?

A technician diagnoses it on site and gives you the price in writing before any work starts.

☎ Call our office ▤ Schedule a Visit