Booking today · Houston · three-hour arrival windows Independent Bosch specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 568-9298 Schedule a Visit
Error code · Dishwasher

Bosch Dishwasher E01: Early Cycle End Tied to Heater Relay and Pump Circuits

Searches for E01 usually land here from owners of the SHEM63W55N, SHEM63W52N and SHEM63W56N, whose display actually reads E:01 with a colon. Bosch's meaning is a wash cycle that ends early, with the far right LED…

Medium · inspection needed
Code
E01
Appliance
Dishwasher
Brand
Bosch
Warranty
30-day workmanship

What E01 means

Searches for E01 usually land here from owners of the SHEM63W55N, SHEM63W52N and SHEM63W56N, whose display actually reads E:01 with a colon. Bosch's meaning is a wash cycle that ends early, with the far right LED flashing. The listed sources are the heat pump heater relay, a heat or drain pump that is unplugged or defective, and supply voltage that drops too low.

Common causes of E01

  • Low supply voltage or excessive voltage drop
  • Heat or drain pump disconnected from the power module
  • Heat pump heater relay has failed
  • Heat pump or drain pump has failed
✓ One safe check you can try

1. Switch the dishwasher off at the breaker for a minute, then restore power. 2. Note whether other loads on the same circuit were running. 3. Run a short test cycle with the kitchen quiet. 4. If the code comes back, leave the lower panel shut and call us for pump and relay testing.

! Why to stop there
  • A guess at the relay or pumps can end in a power module you did not need.
  • Harness and pump checks happen inside the base, which an owner should not open.
  • A cycle that stops early may be a supply problem rather than a part failure.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

Technical reference

Code
E01
Appliance
Bosch dishwasher
Checked
October 2026

We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.

E01E01 questions
Is E01 the same as E:01?

On the SHEM colon-display platform, yes. The documented meaning is an early cycle end linked to the heater relay, pumps and supply voltage. That means the heater relay, both pumps and the incoming voltage are all checked, in that order.

Did an older Bosch use E01 for something else?

Some older models used plain E codes with other meanings. Check your model number, or tell us and we confirm which platform you have. Some older machines used different meanings, so the model number settles it.

How do you handle pricing?

We write the price down before starting and stand behind the work with a 30-day workmanship warranty. A technician can confirm your display and model during a short call before any visit is booked.

Book a visit

Still seeing E01?

A technician diagnoses it on site and gives you the price in writing before any work starts.

☎ Call our office ▤ Schedule a Visit