E000 on a Bosch Range: Control and Panel Disagree

What E000 means

A slide-in range that powers up and then refuses to do anything, with E000 on the screen, has a configuration conflict. Two boards each store a description of the model they belong in (gas or dual fuel, warming drawer or none). When those descriptions differ, the service manual says the range cannot operate. Bosch's documented answer is entering the right option code through service mode, not swapping hardware.

Common causes of E000

A control board was replaced and its option code was never entered
A new board arrived configured for some other range
Panel and control board came from different models during a past repair

✓ One safe check you can try

1. Flip the range's breaker off and wait two minutes. 2. Switch it on again and read the display. 3. Still E000? Stop here: the cure is a model-specific option code typed in service mode, and no owner menu exposes it. 4. Before you call, try to remember whether any board or panel was replaced recently.

! Why to stop there

A wrong option code can leave the range set up for the wrong fuel type or features.
Option codes are model-specific, so a number copied from a forum may belong to a different range.
Service mode is built for technicians, and a slip in it can leave the control locked up until it is reconfigured.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

F91Bosch Range F91 Means the Unlock Attempts Ran Out F92Bosch Range F92: Oven Believes the Door Is Open F93Bosch Range F93 Is the Lock-Side Twin of F90 F94Bosch Range F94: Door Lock Attempts Exhausted F90Bosch Range F90 After Self-Clean: The Door Would Not Unlock E107Bosch Range E107: When the Oven Door Stays Locked E115Bosch Range E115 - Oven Overheated, Door Locked Itself E122Bosch Range E122? Check the Meat Probe First

E000E000 questions

Can I light the burners by hand?

On a slide-in gas range with sealed burners that is often possible with a match. The electric ignition and the oven, however, wait on the very control that is refusing to run, so do not expect those back.

Does fixing this mean buying a board?

Often not. What Bosch documents is entering the correct option code, which is a configuration step. A part only comes into it when a board was damaged or the wrong one was fitted earlier.

How can I tell what caused it?

Think back to the last repair. This code most often appears right after a board or panel was replaced, so tell us what was changed and when; that narrows the search before we even arrive.