Booking today · Houston · three-hour arrival windows Independent Bosch specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 568-9298 Schedule a Visit
Error code · Range

Bosch Range F30: Oven Sensor Circuit Open

When a Bosch Evolution 300 or 500 Series freestanding range with the ES337 control, such as the HGS3023UC, HGS3053UC or HGS5053UC, shows F30, the control has detected an open oven temperature sensor circuit, called Open probe…

Medium · inspection needed
Code
F30
Appliance
Range
Brand
Bosch
Warranty
30-day workmanship

What F30 means

When a Bosch Evolution 300 or 500 Series freestanding range with the ES337 control, such as the HGS3023UC, HGS3053UC or HGS5053UC, shows F30, the control has detected an open oven temperature sensor circuit, called Open probe connection. Note that 1080 to 1110 ohms is the normal healthy reading at room temperature, not the problem value. An open circuit reads far higher than that.

Common causes of F30

  • Oven temperature sensor with an open circuit
  • Loose or broken sensor connector
  • Damaged harness between sensor and control
✓ One safe check you can try

1. Turn the oven off and let it cool completely. 2. Pause the circuit at the breaker for sixty seconds. 3. Try a short bake at a low setting. 4. If F30 returns, stop using the oven. 5. Do not reach in to pull the sensor out; call us and we will measure it against the 1080 to 1110 ohm reference.

! Why to stop there
  • The sensor sits in the oven cavity near hot surfaces.
  • A healthy-looking sensor can still have a broken wire behind it.
  • Replacing the control for a sensor circuit is the wrong fix.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

Technical reference

Code
F30
Appliance
Bosch range
Checked
October 2026

We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.

F30F30 questions
Is 1080 to 1110 ohms the problem?

No, that range is what a healthy sensor reads at room temperature. F30 means the control sees an open circuit instead, far from that figure.

What is the difference between F30 and F31?

F30 is an open sensor circuit, F31 is a shorted one near zero ohms. Both stop the control trusting oven temperature. The oven will not heat reliably until the sensor circuit is back to normal.

Can the sensor be tested at home?

It needs a meter and safe access, so we do it. We quote first and our work carries a 30-day warranty. We also check the wiring back to the control.

Book a visit

Still seeing F30?

A technician diagnoses it on site and gives you the price in writing before any work starts.

☎ Call our office ▤ Schedule a Visit