Bosch Washer dr:08: Drum Speed Sensor Problem
On Vision 16 WFVC front-load washers, whose manual names no US E-Nr, dr:08 means a speedometer failure, the motor's speed reading is missing or wrong. Bosch names a damaged speedometer or its wire harness. The code…
- Code
- dr:08
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What dr:08 means
On Vision 16 WFVC front-load washers, whose manual names no US E-Nr, dr:08 means a speedometer failure, the motor's speed reading is missing or wrong. Bosch names a damaged speedometer or its wire harness. The code is specific to the Vision inverter list and does not apply to Nexxt or current WAT, WAW, and WAP washers. The drum may start, then stop, with the code on the display.
Common causes of dr:08
- Motor speed sensor damaged
- Wire harness to the speed sensor damaged
1. Power the washer down at the dial and wait five minutes with the plug out. 2. Check that nothing is jamming the drum: open the door and turn it by hand once, gently. 3. Close the door and try a short spin. 4. If dr:08 returns, stop. Do not open the back of the washer.
- The sensor sits close to the motor, where only a technician can get to it safely.
- A tight drum can mimic a sensor problem, so we check for friction first.
- You see the cost in writing before any part is ordered.
Technical reference
- Code
- dr:08
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
What is a speedometer in this washer?
It is a sensor that tells the inverter how fast the motor turns. Without it, the drive cannot control the spin. That reading lets the drive hold a steady speed.
Could a jammed drum cause dr:08?
It can confuse the reading, so we check the drum by hand. The documented meaning still points to the sensor or wiring. If the drum turns freely, the sensor path becomes the main suspect.
Is this the same as the E:20 spin codes?
No. Those relate to unbalanced loads on other platforms. dr:08 is a sensor reading problem on the Vision inverter. Er:20 is about balance and communication. dr:08 is about the speed reading that tells the drive how the motor is moving.
Still seeing dr:08?
A technician diagnoses it on site and gives you the price in writing before any work starts.