Bosch Washer dr:10: Power Limiter Switched the Drive Off
dr:10 appears on Vision 16 WFVC front-load washers; the manual names no US E-Nr, and the code is not on Nexxt or current WAT, WAW, and WAP models. It means the power limiter switched the drive…
- Code
- dr:10
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What dr:10 means
dr:10 appears on Vision 16 WFVC front-load washers; the manual names no US E-Nr, and the code is not on Nexxt or current WAT, WAW, and WAP models. It means the power limiter switched the drive off, because the load is too heavy or there is mechanical friction. Bosch says to check the load, the oscillating system, and the gasket. The drum stops mid-cycle.
Common causes of dr:10
- Load too heavy for the drum
- Mechanical friction in the drum or suspension
- Door gasket rubbing the drum
1. Turn the washer off and open the door. 2. Remove some laundry so the drum is no more than about three-quarters full. 3. Check the door seal for anything caught between the drum and gasket. 4. Turn the drum by hand; it should rotate smoothly. Restart a smaller load. If dr:10 returns, call us.
- Friction that is not from the load may come from worn bearings or suspension parts.
- Running a heavily loaded drum again can overheat the motor drive.
- We give you the price in writing before opening the machine.
Technical reference
- Code
- dr:10
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
Is dr:10 just about heavy loads?
Often, but Bosch also lists mechanical friction. If a lighter load still triggers it, we need to inspect the drum and gasket. Check the amount of laundry first.
What is the oscillating system?
It is the suspended drum assembly that moves during spin. If it rubs or binds, the drive needs more power and the limiter trips. Worn parts there raise friction and trigger this code.
How does dr:15 relate?
dr:15 is the early warning from the same limiter. dr:10 is the actual switch-off. Treat dr:15 as notice that dr:10 may follow if the load or friction stays the same.
Still seeing dr:10?
A technician diagnoses it on site and gives you the price in writing before any work starts.