Bosch Washer Er:05: Temperature Sensor Reads as Open
Er:05 is listed for Nexxt front-load washers such as the WFMC6400UC and for Vision 16 WFVC models. Bosch defines it as an open-circuited NTC, the temperature sensor in the tub, caused by a damaged sensor or…
- Code
- Er:05
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What Er:05 means
Er:05 is listed for Nexxt front-load washers such as the WFMC6400UC and for Vision 16 WFVC models. Bosch defines it as an open-circuited NTC, the temperature sensor in the tub, caused by a damaged sensor or a break in its wire harness. The control cannot read water temperature, so the cycle stops or refuses to heat and the code appears on the display.
Common causes of Er:05
- NTC temperature sensor damaged
- Break in the sensor wire harness
1. Turn the washer off and unplug it for a few minutes. 2. Plug it back in and run a cold rinse to see whether the code returns. 3. If it does, stop using hot or warm cycles. 4. Leave the cabinet closed. Do not pull at wires you can see through any gap, and keep the water taps open only while the washer is in use.
- A broken sensor wire and a failed sensor give the same code, so a resistance check is the only way to tell them apart.
- Wires that run beside the drum can be damaged by vibration, and re-seating a connector without finding the break often fails later.
- We give you a written price before ordering the sensor or repairing the harness.
Technical reference
- Code
- Er:05
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
What does NTC mean?
It is the temperature sensor, a small part whose resistance changes with heat. The control reads that resistance to know how hot the wash water is. Er:05 means the reading is open, as if the wire were cut.
Can I still wash in cold?
Possibly, but the control may still stop the cycle. If the washer runs cold rinses without the code, you can use it until repair; avoid heated cycles.
Is the heater damaged too?
Not necessarily. Er:05 is about the sensor circuit. Heater problems have their own codes, Er:07 and Er:08, on the same platform. If you see Er:05, keep heated programs off until the sensor circuit has been checked.
Still seeing Er:05?
A technician diagnoses it on site and gives you the price in writing before any work starts.