Bosch Washer Er:07: Water Heating Without a Heat Command
Er:07 means unexpected heating. On Nexxt front-load washers such as the WFMC6400UC, and on Vision 16 WFVC models, the control saw the water temperature rising when it had not switched the heater on. Bosch ties this…
- Code
- Er:07
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What Er:07 means
Er:07 means unexpected heating. On Nexxt front-load washers such as the WFMC6400UC, and on Vision 16 WFVC models, the control saw the water temperature rising when it had not switched the heater on. Bosch ties this to a bad heater or a stuck heater relay. The washer stops the cycle and shows the code, and the water or the drum glass may feel unusually warm.
Common causes of Er:07
- Heater element failing and heating on its own
- Heater relay stuck closed
1. Turn the washer off at the dial and unplug it. 2. Close the water taps. 3. Do not open the door if the glass feels hot or the drum holds water; let it cool. 4. Leave the washer unplugged until we arrive. Do not try more cycles to see whether the code clears.
- A heater that stays on can overheat the water and the tub, so this is a stop-using-it code.
- Telling a bad heater from a stuck relay needs measurements that should not be taken by an owner.
- We quote in writing before replacing the heater or the board, and the work carries a 30-day warranty.
Technical reference
- Code
- Er:07
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
Is Er:07 dangerous?
It deserves care. Heat without a command means a part may be stuck on. Unplug the washer and keep it off until we inspect it.
Why does the washer stop instead of finishing the wash?
The control is built to halt when temperature and command disagree. Stopping protects the tub, seal, and clothes. Running on would risk heat damage to the door seal, so the stop is deliberate and helpful.
Does Er:08 mean the same thing?
They are related. Er:07 is heat with no command; Er:08 is a heater that will not shut off or ran past its allowed time. Both point at the heater and its relay.
Still seeing Er:07?
A technician diagnoses it on site and gives you the price in writing before any work starts.