Bosch Washer Er:10: Flow Meter Values Make No Sense to the Control
Er:10 appears on the WFMC6400UC, a Nexxt front-load washer; the WFMC3200UC column leaves it blank, and it is not in the Vision 16 table. Bosch defines it as the flow meter giving wrong values, caused by…
- Code
- Er:10
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What Er:10 means
Er:10 appears on the WFMC6400UC, a Nexxt front-load washer; the WFMC3200UC column leaves it blank, and it is not in the Vision 16 table. Bosch defines it as the flow meter giving wrong values, caused by a bad flow meter or a bad wire harness. The washer cannot measure the water it takes in, so it stops filling and displays the code.
Common causes of Er:10
- Flow meter in the water inlet path defective
- Wire harness to the flow meter damaged
1. Turn the washer off. 2. Check that both water taps are fully open and that no hose is kinked behind the washer. 3. Unplug the washer for five minutes and then try a short rinse. 4. If Er:10 returns, close the taps and leave the washer idle. Do not remove hoses or open the cabinet.
- The flow meter is inside the water path, and opening it carelessly can leak.
- Wiring and meter problems read the same, so the check is done with instruments.
- You approve a written price before we change a part.
Technical reference
- Code
- Er:10
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
What does a flow meter do?
It counts the water entering the tub so the control knows how much has arrived. If its count is not believable, the control stops the fill.
Could low water pressure cause Er:10?
Low pressure is more likely to bring Er:11 or Er:12. Er:10 is about the meter's reading, but we still check pressure and inlet screens during a visit.
My WFMC3200UC does not show this code. Why?
That model's table has no entry for it. Only the WFMC6400UC lists Er:10, so an error on your machine may be a different code. We can confirm the exact table for your model number during a visit.
Still seeing Er:10?
A technician diagnoses it on site and gives you the price in writing before any work starts.