Bosch Washer Er:12: Fill Took Too Long
Er:12 means the water supply time was exceeded. It is listed for Nexxt front-load washers such as the WFMC6400UC and WFMC3200UC, and for Vision 16 WFVC models. Bosch points to the inlet valve, the wire harness,…
- Code
- Er:12
- Appliance
- Washer
- Brand
- Bosch
- Warranty
- 30-day workmanship
What Er:12 means
Er:12 means the water supply time was exceeded. It is listed for Nexxt front-load washers such as the WFMC6400UC and WFMC3200UC, and for Vision 16 WFVC models. Bosch points to the inlet valve, the wire harness, or a hose, including a blocked one. The drum fills slowly or only partway, then the washer stops and shows the code. Wet laundry then sits waiting in the drum.
Common causes of Er:12
- Blocked or kinked inlet hose
- Inlet valve opening only partly
- Wire harness to the valve damaged
1. Open both taps all the way. 2. Look behind the washer for kinked or flattened hoses and straighten them gently. 3. Test pressure at a nearby faucet. 4. Run a short rinse after switching the washer off and on. If the fill is still slow, shut the taps and leave the washer alone until we inspect it.
- Debris in the inlet screen can slow the fill, and removing it correctly means shutting off water and catching spills.
- A valve that is only half-working needs testing before a replacement.
- We tell you the price in writing before any work starts.
Technical reference
- Code
- Er:12
- Appliance
- Bosch washer
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Washer codes
How is Er:12 different from Er:11?
Er:11 is no flow in six minutes. Er:12 is a fill that is slower than the control allows. In both cases the inlet path is the first place we look.
Would a water softener cause this?
A softener itself does not, but a sediment-clogged line or a partly closed valve can. We check supply pressure and the inlet screens. Slow fill can also come from a partly closed shutoff, which is a quick check.
Does it use the same code on the WFMC3200UC?
Yes. That model prints it as E:12 with a colon, and the meaning is the same. If your WFMC3200UC prints E:12 instead of Er:12, you have the same issue and the same checks apply.
Still seeing Er:12?
A technician diagnoses it on site and gives you the price in writing before any work starts.