What Er:14 Means on a Bosch Washer That Reached the Safety Water Level

What Er:14 means

The water in the drum has climbed to the maximum the control will allow, and Er:14 is the stop. The Vision manual labels it safety level reached. Bosch's causes cover both directions: something prevents the water leaving, such as a clogged pump or hose, or the inlet valve lets water in when it should be closed. A full tub risks overflow, so the control halts.

Common causes of Er:14

Pump or filter clogged so the tub cannot empty
Drain hose crushed or clogged
Inlet valve leaking through when closed

✓ One safe check you can try

1. Close both water taps behind the washer straight away, since one cause is a valve that keeps admitting water. 2. Unplug the machine. 3. Put a towel and a shallow tray under the pump filter at the lower front. 4. Release the filter slowly, clear any debris, and replace it. 5. Leave the taps closed until we speak.

! Why to stop there

An inlet valve that will not close can keep filling the drum after you open the filter, so water may overflow.
Dirty water released all at once can soak the floor and nearby outlets.
Sorting out whether the water is arriving too fast or leaving too slowly needs a test, not a guess.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

dr:15Bosch Washer dr:15 Gives an Early Warning From the Power Limiter dr:19Bosch Washer dr:19 Shows That the Motor Phases Don't Match dr:20Bosch Washer dr:20 Signals a Shorted Inverter Output Stage dr:21Sustained High Voltage and Bosch Washer dr:21 dr:22Bosch Washer dr:22 Reports Failure of the Inverter's Own Temperature Sensor dr:06Bosch Washer dr:06 and the Inverter's Temperature Protection dr:08A Bosch Washer With dr:08 Has a Drum Speed Sensor Problem dr:09Bosch Washer dr:09 Records a Short Voltage Spike Seen by the Inverter

Er:14Er:14 questions

Why close the taps first?

If the inlet valve is stuck open, water keeps arriving while you work. Closing the taps takes away that risk, and you can reopen them once the cause is found.

Can the washer overflow onto the floor?

It can if the valve sticks open, which is why the control stops at the safety level. The sensor is a backup, and we would not rely on it to protect your floor.

Is Er:14 an emergency?

It deserves prompt attention. If water is rising or leaking, close the taps and switch the power off. If the tub is full but still, you have time to book a visit.