Booking today · Houston · three-hour arrival windows Independent Bosch specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 568-9298 Schedule a Visit
Error code · Washer

Bosch Washer Er:15: Pressure Sensor Voltage Out of Range

Er:15 is listed only on the WFMC6400UC, the Nexxt front-load model that prints Er-style codes. Bosch defines it as the pressure sensor giving a failure voltage level, caused by a bad pressure sensor or a bad…

Medium · inspection needed
Code
Er:15
Appliance
Washer
Brand
Bosch
Warranty
30-day workmanship

What Er:15 means

Er:15 is listed only on the WFMC6400UC, the Nexxt front-load model that prints Er-style codes. Bosch defines it as the pressure sensor giving a failure voltage level, caused by a bad pressure sensor or a bad wire harness. The pressure sensor tells the control how deep the water is, so without a believable signal the washer stops and shows the code.

Common causes of Er:15

  • Pressure sensor defective
  • Wire harness to the sensor damaged
✓ One safe check you can try

1. Let the washer sit unplugged for five minutes. 2. Plug back in and start a short rinse with the door closed. 3. If the code returns, stop and leave the drum empty. 4. Do not blow into or disconnect any tubes you see. Give us the model number so we can bring the right sensor.

! Why to stop there
  • The sensor and its harness give the same reading, so we test them separately.
  • Tubes and connectors on the pressure circuit are easy to disturb, and a displaced one can cause new trouble.
  • A written price comes before any work, and the repair is covered by our 30-day warranty.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

Technical reference

Code
Er:15
Appliance
Bosch washer
Checked
October 2026

We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.

Er:15Er:15 questions
What does the pressure sensor do?

It measures the water level in the tub by reading air pressure. The control uses that to fill, wash, and drain properly. If the reading is off, the washer may overfill or stop early, which is why Bosch watches it.

Why only the WFMC6400UC?

The source table lists it only for that model. Other Nexxt units may have different lists or none. If your model prints a different code for pressure problems, we confirm it on site by its model number.

Will it ever clear itself?

A one-time glitch might clear with a reset. If the sensor or wiring is bad, Er:15 comes back on the next cycle. Do not count on that, because a real problem in the sensor or harness will keep returning.

Book a visit

Still seeing Er:15?

A technician diagnoses it on site and gives you the price in writing before any work starts.

☎ Call our office ▤ Schedule a Visit