Bosch Refrigerator iD: Duct Sensor Reading Lo or Hi
On Bosch 800 and 500 Series Evolution refrigerators such as the B26FT70SNS and B26FT70SNS/04, iD means the IDUCT sensor on the evaporator reads Lo or Hi. The manual calls it the ID-sensor, and it is checked…
- Code
- iD
- Appliance
- Refrigerator
- Brand
- Bosch
- Warranty
- 30-day workmanship
What iD means
On Bosch 800 and 500 Series Evolution refrigerators such as the B26FT70SNS and B26FT70SNS/04, iD means the IDUCT sensor on the evaporator reads Lo or Hi. The manual calls it the ID-sensor, and it is checked at connector CN15 on the main board. Because the sensor feeds the control's air and temperature regulation, cooling may be less steady until it is replaced.
Common causes of iD
- IDUCT sensor on the evaporator has failed
- Loose connector at CN15
- Damaged sensor wire
1. Make sure packaging or tall items are not blocking the vents inside the compartments. 2. Remove power from the refrigerator for five minutes, then reconnect. 3. Put a thermometer inside and check temperatures over the next day. 4. Do not remove interior panels or pull on wires. 5. If iD appears again, call us.
- The sensor sits on the evaporator behind interior panels.
- Board-level readings are needed for a firm answer.
- Our technicians check the connector before replacing parts.
Technical reference
- Code
- iD
- Appliance
- Bosch refrigerator
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Refrigerator codes
Is iD the same as ID in the manual?
Yes. The manual prints it as ID or IDUCT, and the display on your refrigerator shows it as iD. Both refer to the duct sensor on the evaporator.
Does iD put my food at risk?
Only if temperatures drift. A thermometer in each compartment tells you quickly, and if food is warming, move perishables to another refrigerator until the sensor is replaced.
Is this sensor the same as the freezer sensor?
No. The F-sensor, R-sensor and duct sensor are separate parts with separate codes, so iD points us to the duct sensor and its connector instead of the freezer sensor.
Still seeing iD?
A technician diagnoses it on site and gives you the price in writing before any work starts.