Bosch Refrigerator F1: Freezer Sensor Open or Shorted
Bosch 800 and 500 Series Evolution refrigerators such as the B26FT70SNS and B26FT70SNS/01 display F1 when the freezer F-sensor is disconnected, which the manual calls Lo, or shorted, which it calls Hi. Technicians measure it across…
- Code
- F1
- Appliance
- Refrigerator
- Brand
- Bosch
- Warranty
- 30-day workmanship
What F1 means
Bosch 800 and 500 Series Evolution refrigerators such as the B26FT70SNS and B26FT70SNS/01 display F1 when the freezer F-sensor is disconnected, which the manual calls Lo, or shorted, which it calls Hi. Technicians measure it across connector CN14 on the main board. The fix is a new F-sensor. Until then the control has no reliable freezer temperature to work from, so freezer temperatures can drift.
Common causes of F1
- Freezer F-sensor has failed open or shorted
- Loose sensor connector at CN14 on the main board
- Damaged sensor wire
1. Open the freezer briefly and check that food is not pressed against the back wall. 2. Unplug the refrigerator for five minutes, then plug it back in. 3. Place a thermometer in the freezer and check it after a few hours. 4. If F1 returns, or the freezer feels warm, move frozen food to another freezer and call us.
- The sensor is behind liners inside the freezer.
- Measuring across CN14 means reaching the main board.
- A reset only helps if the cause was a one-time glitch.
Technical reference
- Code
- F1
- Appliance
- Bosch refrigerator
- Maker documentation
- Bosch owner manuals and support
- Checked
- October 2026
We read the code from the maker’s documentation and our own service work, and we do not reproduce the maker’s document. Always confirm the full model number before acting on a code. We are an independent repair company, not affiliated with Bosch.
Other Refrigerator codes
What do Lo and Hi mean for F1?
Lo means the sensor circuit reads as disconnected, and Hi means it reads as shorted. In both cases the control loses its freezer temperature reading, which is why the sensor is replaced instead of adjusted.
Will my frozen food spoil?
It might, if the freezer warms while the control is guessing. Check with a thermometer, and if food has started to thaw, move it to another freezer until we have repaired the sensor.
Where is the sensor tested?
Across connector CN14 on the main board, according to the Bosch table. We take that reading ourselves, so you do not need to open the freezer liner or touch the board.
Still seeing F1?
A technician diagnoses it on site and gives you the price in writing before any work starts.