Bosch Washer E:36 and Drain Trouble on Newer Machines

What E:36 means

On newer Bosch washers E:36 means water is not leaving the drum, and the display tacks on a two-digit detail such as -10, -25 or -26. Per the user manual, every listed cause sits on the drain side: a clogged or bent outlet hose or pipe, a blocked pump, a hose attached too high, or a pump cover put back incorrectly.

Common causes of E:36

Pump or pump filter plugged
Outlet hose bent, pinched or clogged
Hose fitted above the allowed height, or pump cover not seated properly

✓ One safe check you can try

1. Unplug the washer. 2. Follow the manual's steps to open and clean the drain pump, with towels and a pan underneath. 3. Straighten the outlet hose and confirm it rises no higher than about one meter. 4. Press the pump cover on fully and squarely. 5. Plug in and run a short drain program.

! Why to stop there

Water in the pump housing can spill when the cover comes off, so power should be disconnected.
A cover that is not seated square leaks and can set off the error again.
Raising or lowering the hose without checking the manual's limit can create a siphon or a backup.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

dr:15Bosch Washer dr:15 Gives an Early Warning From the Power Limiter dr:19Bosch Washer dr:19 Shows That the Motor Phases Don't Match dr:20Bosch Washer dr:20 Signals a Shorted Inverter Output Stage dr:21Sustained High Voltage and Bosch Washer dr:21 dr:22Bosch Washer dr:22 Reports Failure of the Inverter's Own Temperature Sensor Er:24Bosch Washer Er:24 Names the Relay That Feeds the Motor Drive Er:25Bosch Washer Er:25 When the Door Lock Coil Overheats dr:01The dr:01 Code on a Bosch Washer: Inverter Power Switch Shorted

E:36E:36 questions

What are the extra digits after E:36?

Those are detail codes, for example -10, -25 or -26, that narrow down the cause. The underlying problem stays the same: water is not draining. Jot down the whole code to tell us when you call.

Why does hose height matter?

Bosch specifies a maximum of about one meter. A higher outlet makes the pump work harder and can fail to empty the drum, which triggers the error.

Is it safe to use the washer between cleanings?

Not if the drum holds water. Drain it, check the pump, and avoid running more loads until water leaves normally. Standing water also encourages odors and puts strain on a pump that is already struggling.