Bosch Oven E310 Signals a Settings Memory Failure on the Control Module

What E310 means

While E010 reports the same trouble on the user interface, E310 places it on the control module. Either its routine review of stored data came up wrong, or an attempt to save data did not finish. With the memory in doubt, the oven refuses to heat. That stored data includes the configuration the oven needs to run properly, which is why it holds back. A clean check at the next start-up cancels the error.

Common causes of E310

Data memory on the control module corrupted
A write cut short by loss of power
Hardware failure on the control module

✓ One safe check you can try

1. Turn the breaker off for about two minutes and restore it. 2. Check the clock and any saved settings. 3. If they have reset themselves, the memory really lost content and did not just fail one check, and that is useful for us to know. 4. If the oven still will not heat, leave it off.

! Why to stop there

The board sits in a hot, tight spot beside live wiring.
Memory that lost its configuration cannot be fixed by resetting alone.
A failing board that is ignored can leave you without the oven at the worst moment.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Oven codes

E223Lower Probe Reads Colder Than Allowed (Bosch Oven E223) E226Bosch Oven E226 After the Lower Door Latch Signal Is Lost E309Control Module Failed Its Program Memory Check: Bosch Oven E309 E312The Control Board's Own Heat Sensor Died (Bosch Oven E312) E314Bosch Oven E314 When the Cancel or Off Key Reads Stuck E414Off Key Failure Logged Behind the Scenes, Bosch Oven E414 E201Bosch Oven E201 on a Double Wall Model, Lower Cavity Sensor Reads Open E204Lower Sensor Wire Touching Metal: Bosch Oven E204 on Double Ovens

E310E310 questions

Why will the oven not heat with E310?

Without trustworthy stored data, the control cannot be sure of its configuration, so it keeps the elements off. That is a protective choice, not a defect in the heating parts.

Will my settings come back?

If the memory is damaged, saved settings may be lost. A replacement board starts at defaults, and you can re-enter your preferences after the repair.

Is it worth repairing an older oven?

That depends on the oven's age and the board price. We give you a written price, so you can compare it with the cost of a new oven before deciding.